Knowledge hub / MusicMuse / gear
Instrument into rig — Post-Prog-Metal
Music knowledge / Guides and practical tools
About this reference
From the music-learning collection, adapted for Philojain Music Muse. Referenced sources remain credited in the article.
Instrument into rig — from What Goes Into What.
Instrument into rig (5)
36. THE SILENCE IS THE RHYTHM
Eight-string → Gated high-gain chain — The djent direct rig, The scooped Mesa rig
- Mechanisms: Multiscale, Downtuning tension loss, Two-gate detection, Pre-clipping high-pass, Band-limiting, Inharmonicity
- The move: An extended-range instrument into a chain built to remove almost everything it produces.
- The friction: The low string's fundamental is high-passed away before the gain stage, the ring is gated off after it, and the cabinet band-limits everything above 5 kHz. What is left is an attack and a reconstructed pitch. The friction is that the instrument is chosen for its low fundamental and the rig is engineered to discard it.
- The recipe: Multiscale or a 27″-plus scale, because a whole step down at standard scale leaves about 79% of the tension and the inharmonicity rises with it. High-pass before the drive rather than after. Two gates, keyed off the clean signal. And do not add low end at the amp to compensate — the low end you want back is the one the high-pass is there to remove.
Mechanical, hypnotic, extremely heavy instrumental guitar built on a repeating polymetric figure, 104 BPM, five minutes. The lowest guitar is an eight-string with a very long scale so the low strings stay tight rather than floppy, tuned low and palm-muted, high-passed so the fundamental is removed before the distortion and gated so tightly afterwards that every note is a short discrete event with no ring at all. What reaches the listener is a hard dry click around 2 to 4 kHz over a compressed midrange grind, and the pitch is reconstructed by the ear from harmonics rather than heard directly. The figure is seven beats long against drums holding a completely steady four-four, so it lands somewhere different on every repetition and only realigns after a long cycle. The silences between the chugs are absolute and are as rhythmically important as the notes. A second guitar in the middle register plays a bright clean interlocking pattern in the gaps. Bass doubles the low guitar exactly, with a bright pick attack that supplies the fundamental the guitars have thrown away. It ends on one unison accent.
37. A SPEAKER THAT CANNOT PLAY THE NOTE
Bass → Cranked guitar amp — Instruments through the wrong rig, The doom and sludge rig
- Mechanisms: Band-limiting, Mechanical non-linearity, Bridging ratio, Multiple drivers, Slapback
- The move: A bass guitar into an amplifier and cabinet specified from about 70 Hz upward.
- The friction: The speaker physically cannot reproduce the fundamental, so what you hear is upper harmonics plus cone distortion. That is a defect on paper and it is the classic fuzz-bass recording sound — the amplifier is being used as a distortion generator rather than as an amplifier, and the missing fundamental is supplied by a separate clean DI.
- The recipe: Split the bass: one path clean and direct for the low end, one path into the cranked guitar amp for the grind, and blend. Keep the guitar-amp path high-passed so you are not asking the cabinet to do something it will fail at destructively. Watch the excursion — a low-wattage vintage driver will not survive this for long.
Enormous distorted bass carrying an entire piece with no guitar at all, four minutes, 88 BPM, filthy and physical. Two bass signals run together: one completely clean and direct, supplying the deep fundamental with no distortion whatsoever, and one driven through a small cranked valve guitar amplifier whose speaker cannot reproduce those low frequencies at all — so that path returns only upper harmonics, ragged cone distortion and midrange snarl. Blended, the result is a bass that is simultaneously deep and viciously aggressive, with a growling, torn midrange sitting on top of a solid low end. Playing is with a pick, hard, on a simple repeating riff with a lot of open strings and slides. The distorted path is high-passed so the cabinet is not asked to move air it cannot move. Drums are loud, live and simple, with a heavy backbeat. There is no guitar in the arrangement anywhere — the bass occupies the whole midrange. A short slapback delay sits on the distorted path only. Everything is mono and close-recorded. It ends on a held low note with the distorted path feeding back.
38. AN AMP THAT WILL NOT BREAK UP
Guitar → Bass rig — Instruments through the wrong rig, The doom and sludge rig
- Mechanisms: Band-limiting, Wattage and headroom, Cascaded clipping, Downtuning tension loss, Multiple drivers
- The move: A guitar into a flat, high-power, extended-range amplifier that has no intention of distorting.
- The friction: Everything a guitar amp normally contributes — band-limiting, cone breakup, power-stage compression — is absent. The rig is clean, loud and honest, so all character has to come from pedals, and every harshness a guitar cabinet would have rolled off above 5 kHz arrives intact.
- The recipe: Put a cabinet simulator or a fixed low-pass around 5 kHz somewhere in the chain, or the fizz will be unbearable. Then treat the amplifier purely as a monitor. The reward is enormous low-frequency extension, which is why doom and some ambient rigs use it deliberately — a downtuned guitar through a bass cab has fundamentals a twelve-inch guitar speaker never reproduces.
Vast, downtuned, slow guitar music with far more low-frequency extension than a guitar cabinet could produce, seven minutes, 58 BPM, enormous and patient. The amplifier is flat, high-powered and refuses to break up at any volume, so it contributes no compression and no distortion of its own — every bit of the character comes from a fuzz in front of it, and the cabinet reproduces frequencies far below what a guitar speaker can move. Downtuned power chords therefore arrive with genuine sub-bass weight underneath the fuzz, physical rather than merely loud. A fixed low-pass keeps the top end from becoming unbearable, since there is no speaker rolling it off. Tempo is slow enough that the decay of each chord becomes the structural event: notes are struck, allowed to bloom, sustained into feedback and left to die before the next arrives. The harmony never moves off a single modal centre. Drums are sparse, huge and slightly behind the beat, with long gaps. Bass doubles the guitar an octave below. No vocals, no resolution. It ends with one chord left ringing until the feedback collapses.
39. LOW NOTES A TWELVE-INCH CAN ACTUALLY MOVE
Bass VI → Surf rig — Instruments through the wrong rig, The surf rig
- Mechanisms: Inharmonicity, Scale length, String alloy, Spring reverb, Bias tremolo
- The move: A short-scale six-string bass into ordinary guitar gear, which works where a real bass would not.
- The friction: A Bass VI's output sits in guitar territory and its short scale keeps the fundamental inside a twelve-inch speaker's usable range, so the cabinet is not being asked to do the impossible. The trade is inharmonicity — thick strings at a short scale have high stiffness, so the overtones drift sharp and it never sounds quite in tune with itself.
- The recipe: Use the tone circuit: a Bass VI's own low-pass switching exists because the instrument is otherwise clangy. Flatwounds tame the inharmonicity. Keep the amp clean and let the spring reverb and tremolo do the work — distortion on top of an already-inharmonic low signal is where this stops working.
Dark, cinematic, twanging low-register instrumental music, four minutes, 104 BPM, ominous and reverberant. The instrument is a short-scale six-string bass played with a pick through ordinary guitar amplification, so its low notes stay within what a twelve-inch speaker can reproduce — deep and thick but articulate rather than shapeless. The strings are heavy and flatwound and the tone is rolled well back, which tames the slight sharpness of the overtones that comes with thick strings at a short scale. Everything runs into a hard-driven mechanical spring reverb tank, splashing and crashing on every attack, with a fast valve tremolo pulsing underneath from the amplifier's own bias modulation. Playing is single-note melodic lines low on the neck with heavy palm muting and long glissando slides, plus occasional fast tremolo picking. The amplifier stays clean with plenty of headroom. Drums are simple, hard-hit and roomy with heavy use of the floor tom. A distant clean guitar plays sparse high answering figures. Everything is mono and reverberant. It ends on a low sustained note left to ring through the reverb until it disappears.
40. A SOURCE WITH NO RESONANT PEAK
Piezo acoustic → Electric pedalboard — Instruments through the wrong rig, The stereo ambient rig
- Mechanisms: Bridging ratio, Pickup resonant peak, Buffer, Chorus, Algorithmic vs convolution
- The move: An undersaddle piezo pickup into a chain that was designed around a magnetic pickup's RLC behaviour.
- The friction: A magnetic pickup is an inductor with a resonant peak and a rising source impedance; a piezo is a capacitive source with a very high output impedance and a flat, extended, brittle response. Nothing in a guitar pedalboard is voiced for that, and every impedance-sensitive circuit in the chain behaves unexpectedly.
- The recipe: A dedicated high-impedance preamp first — a piezo needs 1 MΩ or more to avoid losing its low end, and an ordinary buffer is not enough. Then a fixed low-pass to remove the quack. After that, everything downstream behaves normally. Do not put a fuzz first: it will load the piezo and sound like nothing at all.
Amplified steel-string acoustic guitar processed through electric guitar effects, five minutes, 96 BPM, bright and unnaturally wide. The pickup is an undersaddle piezo, so the source is capacitive and its response is flat and extended rather than peaking anywhere — the raw tone is very bright, immediate and slightly brittle, with an exaggerated attack and a fast, quacking edge. A high-impedance preamp comes first so the low end survives, then a gentle fixed low-pass removes the harshest part of the quack. After that the signal runs through a full electric chain: a light compressor, a long stereo delay, a large reverb, and a slow chorus. The result is an acoustic instrument in an entirely unacoustic space — every string sound is hyper-detailed and close, while the ambience around it is enormous and clearly electronic. Playing is fingerstyle in an alternate tuning, with the thumb running a steady alternating bass under an independent syncopated melody, plus percussive taps on the body of the guitar between the notes. Those body hits come through the piezo as sharp, dry thumps. Bass and drums are absent. It ends on a harmonic left to ring into the reverb.
Keep exploring